OGI TotalArc BMS 460246 SOLAR POWER, Руководство оператора

Страница: 15 / 24

ASSEMBLY
6
IGNITION MODULE INSTALLATION
This product requires assembly.
Ignition module must be installed inside the
flame arrestor via a 1 ¼” diameter hole in the
flame arrestor wall. Ignition module MUST be
installed on a flat surface.
Perform an initial inspection of the interior of the
flame arrestor to confirm there is proper installation
room inside the flame arrestor.
Ignition module is provided with two stainless steel
washers and two rubber washers. Install washers
according to Figure 2 (pg.II) to provide a water tight
connection between flame arrestor and the ignition
module.
CONTROL PANEL INSTALLATION
This product requires assembly.
Install the control enclosure within reach of the
cable provided with the unit (varying lengths
available upon request).
Control panel must be installed in the vertical position
and leveled, allowing the battery to sit flat in the
bottom of the enclosure when applicable.
Control panel includes mounting feet for easy
installation on a flat surface. See Figure 3A & 3B (pg.
III)
CABLE AND CLAM SHELL ASSEMBLY
WARNING - BEFORE BEGINNING THIS STEP
CONFIRM THAT THE POWER SWITCH IS IN
THE OFF POSITION.
Cable assembly between control panel and
ignition module is a polarized cable.
Line up keyway between connector and the
receptacle, insert connector into receptacle, and
carefully turn connector clockwise to thread
connector.
Once the connection is made, install clam shell
around the connectors (See Figure 4 pg IV). These
shells are required to maintain Class 1 Division 2
rating. Failure to apply clam shells could lead to a
hazardous work environment.
Do NOT connect or disconnect cable assembly while
power is on.
POWER CONNECTIONS
The TotalArc system is shipped full factory wired
except for the power system. See wiring instructions
for all power options:
Solar Power TotalArc (p/n 460246):
Solar Panel Wiring:
WARNING – MAINTAIN SOLAR PANEL
COVER UNTIL TOTALARC UNIT IS FULLY
INSTALLED AND SOLAR PANEL
IS TERMINATED IN ENCLOSURE
1. Run solar panel SO Cord cable through cable
gland on bottom of enclosure
2. Insert enough length of wire to reach the
terminal blocks.
3. Tighten cable gland.
4. Terminate Solar Panel Wires:
•
Black Wire to Terminal Block 2
•
White Wire to Terminal Block 9
Battery Connection:
1. Install battery inside enclosure; Make sure it
sits flat in bottom of enclosure.
2. Connect Red wire to Red battery terminal
3. Connect Black wire to Black battery
terminal
4. Install battery terminal connectors
according to Figure 5 (pg. IV)
120VAC Power TotalArc (p/n 460246):
Grid Power Wiring:
**All field wiring and conduit to be sized
by an electrical contractor**
1. Run conduit connection into plugged Myers Hub
on bottom of enclosure panel
***WARNING: PROPER HAZARDOUS
LOCATION WIRING METHODS MUST BE USED
WHEN INSTALLING AND TERMINATING THE
TOTALARC RELIGHTER***
2. Insert enough length of wire to reach the terminal
blocks.
3. Terminate wires to terminal blocks:
•
Black wire to Terminal Block L
•
White wire to Terminal Block N
•
Green wire to ground lug on back panel