9
10.1.3.
Status information hand-held meter
Charging status
When the charging status is flashing, the battery is fully-
charged. In this picture, there is still 100% battery capacity
available
▼
__
▲
Transient mode - measurement value unstable
The distance between the arrows shows that the measurement
value is not stable yet. The value measured should not be used
yet.
▼
▲
Transient mode - measurement value stabilising
Once the arrows meet in the middle, the measured value is as
stable as possible.
CAUTION: Drift may still arise over time !!!
Number values on the display should be noted.
Calibrate the sensor
Reminder
3 x flashes after switching on the device remind you that the
last calibration took place over 30 days ago.
This display only acts as a note and reminder.
It has no influence on other measurements.
10.1.4.
Socket panel
1
Socket for USB sensor cable for charging the battery and for data transfer
2
Sockets for connecting the sensors.
There is no fixed assignment of the two sockets for the sensors.
Connection for the sensors supplied can be chosen freely.
10.2
Switch on the hand-held meter
Switch on the device using
[ON/OFF].
Then the OFS logo and the software version number
are shown briefly on the display. Then comes the measurement view in the main menu.
1
2
2
100%
Содержание udox
Страница 1: ...dox Operating instructions Version 1 6 8...
Страница 2: ......