FREESTANDING TABLE
INSTALLATION INSTRUCTIONS
IMPULSE G2/PULSE
INSTRUCTIONS
CONTROL BOX
CONTROL PANEL
Use "hook" for mains cable
(power cord) relief.
FREESTANDING TABLE
ASSEMBLY
Align two thru holes in control
•
box with pre-drilledholes on
bottom side of work surface.
Use (2) #8 x 2" pan head screws
•
to secure to work surface.
To attach control panel, determine
•
if control panel is to be on the
left or right side of the work surface.
Align control panel mount plate
•
with pre-drilled holes.
Use (2) X8 x 5/8" pan head screws
•
to secure to work surface.
NOTE: When attaching control box, use
the grooves on the upper face to help
manage motor cables.
Rev:
Dwg:
INSTRUCTIONS
CONTROL BOX
CONTROL PANEL
Use "hook" for mains cable
(power cord) relief.
FREESTANDING TABLE
ASSEMBLY
Align two thru holes in control
•
box with pre-drilledholes on
bottom side of work surface.
Use (2) #8 x 2" pan head screws
•
to secure to work surface.
To attach control panel, determine
•
if control panel is to be on the
left or right side of the work surface.
Align control panel mount plate
•
with pre-drilled holes.
Use (2) X8 x 5/8" pan head screws
•
to secure to work surface.
NOTE: When attaching control box, use
the grooves on the upper face to help
manage motor cables.
Rev:
Dwg:
8. Align two thru holes in control box with
pre-drilled holes on bottom side of work
surface.
9. Use (2) #8 x 2" pan head screws to secure to
worksurface.
10. To attach control panel, determine if control
panel is to be on the left or right side of the
worksurface.
11. Align control panel mount plate with
pre-drilled holes.
12. Use (2) X8 x 5/8" pan head screws to secure
to worksurface.
Control Box
NOTE: When attaching control box, use the grooves on
the upper face to help manage motor cables.
Control Panel
Use “hook” for mains cable
(power cord) relief.
PAGE 2 OF 3
