2
Adjust
Scale for adjusting the diameter
Release attachment screw, determine
scale, adjust diameter, tighten
attachment screw
Adjust distance edge to
according diameter turn knob
Turn knob index to the
according diameter (e.g. 3/8”)
bigger 0 – bigger edge.
Adjust format 11” Paper guide right
Pull pins
Screw down the right paper guide, pull
5 pins from left (21 loops).
Adjust format 8.5” Paper
guide left
Pull pins
Screw down the left paper
guide, pull 5 pin s from left
and 5 pins from the right (16
loops).
3
Insert
Lay binding element in front of the
clamping fixture
Small loops on top, facing rear.
Press down clamping fixture
Press back edge and front side
will open.
Push binding element under the
clamping fixture.
Clamping fixture holds binding element
during insertion of the punched paper.
Release clamping fixture
possibly adjust binding
element vertically.
4
Prepare
The seam of the closed binding
element should be inside the book
Not outside the covers
Set the book upright, binding
side to the top, place the back
cover in front
The front cover should be
behind the back cover.
Jog the book
Turn the book over, covers are
underneath
Take pages from the top
5
Punch
Punch max 30 pages 20# stock,
for comfortable punching: 15 –
20 pages
Punch plastics and thicker covers
separately.
Insert paper into punching slot,
slide the paper against the paper
guide
Adjust 11” format at the right
side, paper must stand evenly, if
not align it again
Adjust 8.5” format at the left
side.
Press punching level forward
until it stops, then return to
original position.
Hold the machine with the other
hand.
6
Insert
Remove punched paper from the
punching slot.
Insert paper onto the binding
element
For thicker books, repeat steps five and six until all pages are
punched.
