Ensure all bolts and screws are tightened, check bolts and screws every 6 months.
If any parts are missing, broken, damaged or worn, stop use of product until repairs have been made using factory authorized parts.
Failure to follow these warnings may result in injury.
ATTENTION
!
!
Nylon Clip
qty = 2 pcs
qty = 10 pcs
Flat Bracket (Tie Bracket)
1 of 2
qty = 2 pcs
Mid Cap
In the Carton :
In the Carton :
Self drilling screw
@ #6x1/2" = 28 pcs
nylon clip
face-down
nylon clip
face-up
nylon clip side
In the Carton :
In the Carton :
1
M6x16 bolt
qty = 6 pcs
screw #10x5/8"
Qty = 8 pcs
qty = 2 pcs
V base castor Leg
1. Lay the panels down on a flat clean surface for assembly
2. Remove the end caps (side trim) from the panels from both sides of each panel
3. Install 5 of the nylon clips face up (see image to the right) to the side being joined on one of the panels
a. Screw the nylon clips to the panels using 2 of the #6 x ½” Self drilling screws. There will be 3 holes
drilled in a triangular shape – leave the center hole empty
4. Install 5 of the nylon clips face down (see image to the right) to the side being joined on the other panel
a. Screw the nylon clips to the panels using 2 of the #6 x ½” Self drilling screws. There will be 3 holes
drilled in a triangular shape – leave the center hole empty
(PPPDELFOOTCPR)
Sold Separately :
acrylic
Before assembly, please remove all parts from carton, verifying that you have the correct quantities, and read all the insructions.
ASSEMBLY INSTRUCTIONS
MODEL: PPPSTRAIGHT
Leg bracket
nylon clip side
5. Install the V Base Castor Leg to the outside of the 2 connected panels,
following the instructions outlined in the V Base Leg, model #
PPPDELFOOTCPR, (sold separately).
6. Re-attach panel side trims to the outsides of the panels (the same sides
the V Base Caster Leg is on)
Last Updated: 02/2021
MODEL NO. PPPSTRAIGHT
OFFICESOURCE.COM
ASSEMBLY INSTRUCTIONS
Last Updated: 3/2023
