© Office Star Products March 2008
PART
QTY
1. Top Panel . . . . . . . . . . . . . . . . . . . 1
2. Side Panel . . . . . . . . . . . . . . . . . . . 2
3. Cross Apron . . . . . . . . . . . . . . . . . . 1
4. Cam Lock . . . . . . . . . . . . . . . . . . 11
5. Cam Lock Stud . . . . . . . . . . . . . . 11
6. Wooden Dowel . . . . . . . . . . . . . . 12
7. Small Plastic Cap . . . . . . . . . . . . . 7
8. Large Plastic Cap . . . . . . . . . . . . . 4
IMPORTANT NOTE:
1. Use hand tools only for assembly as power tools may
cause damage
2. Carefully remove any staples used for packaging.
Phillips Screwdriver also needed for
assembly (not provided)
STEP 1
STEP 2
1
3
4
6
2
5
DETAIL A
DETAIL B
DETAIL C
DETAIL D
2
4
2
2
6
5
Remove all parts from carton, separate by part numbers indicated on parts list, and verify part quantities.
STEP 1
Insert two Cam Lock Studs (5) into each Side Panel (2), Insert two Wooden Dowels (6) into each end of Cross Apron (3)
AS SHOWN IN dETAIL A
. Attach Side Panels (2) to Cross Apron (3) and secure using four Cam Locks (4), cover holes in Cross Apron (3) using four
Small Plastic Caps (7),
AS SHOWN IN dETAIL B.
STEP 2
Place Top Panel (1) face down on a soft surface, Insert eight Wooden Dowels (6) and seven Cam Lock Studs (5) into bottom of Top Panel (1),
AS SHOWN IN dETAIL C
. Align and attach assembled Side Panels (2) and Cross Apron (3) to Top Panel (1), secure using
eight Cam Locks (4), cover holes in Cross Apron (3) using three Small Plastic Caps (7)
AS SHOWN IN dETAL d
, then cover holes in Side Panels (2)
using four Large Plastic Caps (8)
AS SHOWN IN dETAIL E
.
ATTENTION: MAKE SURE ALL CAM LOCKS ARE FULLY TIGHTENEd BEFORE USING TABLE.
CT7236RT3 (MAHOGANY), CT7236RT7 (CHERRY) CONFERENCE TABLE
ASSEMBLY INSTRUCTIONS
7
DETAIL E
7
4
8
