OETIKER CC 20, Инструкция по эксплуатации, Страница: 38 / 58

Clamp pincer CP 10 / CP 20 / CC 20 6 Maintenance and repair
Issue 06.19 08902961 6-38
6. Remove the side plate (Fig. 28/9).
Fig. 28: Removing the side plate
7. Remove the compression spring (Fig. 29/11),
cover plate (Fig. 29/12) and pincer jaws
(Fig. 29/10).
8. Grease and assemble replacement pincer jaws
(Fig. 29/10) and compressions spring
(Fig. 29/11) from the pincer jaw replacement kit
and pin (Fig. 29/14) with special lubricant
RENOLIT LX-EP 2 (RENOLIT Duraplex EP 2).
9. Reassemble in reverse order,
using new
lock
washers (Fig. 27/6)
.
10. Check mobility of pincer jaws (Fig. 29/10).
11. Screw the pincer head on to the clamp pincer
and, holding the adapter, tighten the union nut.
The plunger (Fig. 26/2) must lie between the
two pincer jaws (Fig. 29/10).
Fig. 29: Fitting the pincer jaws