Oerlikon Leybold Vacuum 230001, Инструкция по эксплуатации

Страница: 14 / 24

5.2.3 Panel Mounting
When wanting to install the instrument in a front panel, the following panel cut is required
(
) Figure 2, page 8):
•
Insert the DISPLAY ONE into the cut-out
•
Affix the instrument with 4 M2.5 screws
5.3 Connections
5.3.1
Rear of the Instrument
Figure 3, page 12 shows the rear of the DISPLAY ONE. The pin assignment of the
individual connections is described in the following chapters.
Figure 3 – Rear of the instrument
A Mains connection with mains switch and device fuses
B Connection for transmitter ( ) Figure 4, page 13)
C Connection for relay output and analogue output ( ) Figure 5, page 13)
D Configuration switch
5.3.2 Mains Connection
The mains connection on the rear of the instrument ( ) Figure 3 A, page 12) is intended
for a mains cord which on the instrument side has been fitted with a rubber connector.
DANGER: Mains voltage
Not professionally grounded devices can in case of malfunction endanger life.
Use only three core mains cables respectively extension cables with a
protective ground connection. Insert the mains plug only into a mains outlet
with a protective ground contact.
12 GA 09.034/2.02 – 07/10