3
Operating Instructions and Parts Manual
OEM24893/OEM24894
5/20
2020 OEMTOOLS
®
24"/30" OUTDOOR OSCILLATING
WALL MOUNT FAN
CONTENTS
(1) 24"/30" Outdoor Oscillating Fan, (1) Wall Mount
Assembly, Mounting Hardware, (1) Instruction Manual
SPECIFIC SAFETY INSTRUCTIONS
AND WARNINGS
WARNING
: Thoroughly read and understand the
provided product manual before attempting to use this
product.
WARNING
: DO NOT attempt to disassemble, repair,
or modify this fan.
WARNING
: DO NOT insert your hand or other objects
into the fan guard or near moving parts.
WARNING
: DO NOT submerge this fan in liquids.
WARNING
: DO NOT touch this fan with wet hands.
WARNING
: DO NOT use this fan if the cord or plug
has been damaged.
WARNING
: Ensure the wall mount is fastened to a
concrete wall or stud capable of supporting the weight of
the fan.
WARNING
: Fit the front and rear guards to the fan
prior to attempting to start the fan.
1. DO NOT unplug this fan by holding the cord. Unplug
this fan by holding the plug.
2. DO NOT plug this fan into an extension cord.
3. DO NOT operate near an open flame or heat source.
4. DO NOT use this fan in conjunction with a solid-state
speed control device.
5. DO NOT leave this fan plugged in while unattended.
Always unplug the fan when not in use.
6. DO NOT move or attempt to perform maintenance
while this fan is plugged in.
ASSEMBLY INSTRUCTIONS
NOTE: Remove all contents from the box and reference
the parts list to ensure that all parts are present.
1. Wall Installation
WARNING
: DO NOT mount on dry wall.
a. Concrete Wall Installation
1) Mark the desired hole location using the Wall
Mounting Bracket, then drill the holes.
2) After drilling, insert the wall anchors and tap
them until flush with wall face.
3) Position the Wall Mounting Bracket and screw the
3 bolts into the anchors. Tighten the bolts securely.
b. Wall Stud Installation
1) Mark the desired hole location using the Wall
Mounting Bracket, then drill small diameter
pilot holes.
2) Position the Wall Mounting Bracket over the
pilot holes and screw the 3 bolts into the stud.
Tighten the bolts securely.
2. Connect the Swivel Adapter to the Mounting Bracket
using the M12x120 bolt, flat washer, locking washer,
nut, and rivet assembly (applied in that order).
Assemble the rear grill.
Assemble the blade.
Assemble the front grill.