OEM MILLENNIUM 1235/E, Инструкция по установке и эксплуатации

Страница: 6 / 38

MILLENNIUM MM/MB
General specifications and warning
GB - 4
- THESE SAFETY REGULATIONS INTEGRATE OR
COMPLEMENT THE LOCAL SAFETY REGULATIONS.
- NEVER carry out hasty or makeshift repairs which
could jeopardize the oven functioning and user’s safety,
as well.
- IN CASE OF DOUBT ALWAYS ASK FOR THE PRESENCE
OF SKILLED PERSONNEL.
- MANUFACTURER DISCLAIMS ALL RESPONSIBILITY
IN CASE OF ELECTRIC, ELECTRONIC, MECHANICAL
TAMPERING OF THE OVEN BY USER OR
CARELESSNESS OF USER BY USING IT.
1.2 - REFERENCE NORMATIVE
- The oven and its safety devices have been built
according to the rules being indicated in the declaration
of conformity.
1.3 - DESCRIPTION OF THE SYMBOLS
Several accidents are due to an insufficient
knowledge and a lack of fulfilment of safety rules to
be considered during functioning and maintenance
of the oven.
To avoid accidents, all warning notes and
instructions contained in this handbook as well as
the ones being reported on the oven plates, shall be
read, understood and observed.
To identify the safety messages included in this
booklet, following symbols have been used:
DANGER
This symbol is used in the safety messages
contained in the booklet in case of potential danger
situations or possibility to cause serious injuries or
dead.
ATTENTION
This symbol is used in the safety messages of the
booklet for any danger situation that, if disregarded,
may cause small or moderate injuries or damages.
The message can also be used as to dangers which
can damage the oven.
IMPORTANT
This symbol is utilized in order to avoid operations
which could result a shorter oven life or for important
messages to user.
DANGER
For clearness purposes, some pictures in this
handbook show the oven without protection
structures. DO NOT USE THE OVEN WITHOUT
PROTECTION STRUCTURES.
1.4 - OVEN COMPOSITION
Manufacturer’s ovens are the result of a several year-
experience.
• Single-chamber, two-chamber or three-chamber
ovens with digital or manual functioning.
• Over the oven, an extractor hood controlled by a
special board can be installed.
• The oven/s are supported by a bearing base.