3
Operating Instructions and Parts Manual
24885
30" OSCILLATING PEDESTAL FAN
10. DO NOT use this fan outdoors.
11. DO NOT operate any 30" Oscillating Pedestal Fan with a
damaged cord or plug. Discard fan or return to an authorized
service facility for examination and/or repair.
12. DO NOT run cord under carpeting. DO NOT cover cord with
throw rugs, runners, or similar coverings. DO NOT route cord
under furniture or appliances. Arrange cord away from traffic
area and where it will not be tripped over.
13. DO NOT use if electrical cord is frayed or bent.
14. DO NOT immerse the 30" Oscillating Pedestal Fan in water.
CAUTION
15. Fit the guard onto fan before starting up the 30" Oscillating
Pedestal Fan.
16. This fan is not intended for use by people (including
children) with reduced physical, sensory or mental
capabilities or lack of experience and knowledge
unless they have been given supervision or instructions
concerning use of the fan by a person responsible for
their safety. Supervise children to ensure they DO NOT
play with the 30" Oscillating Pedestal Fan.
17. Always place the fan on a stable, flat, level surface when
operating, to avoid the chance of the 30" Oscillating
Pedestal Fan overturning.
ASSEMBLY
1. Fix the Lower Pole on the Base with Screws.
2. Insert the Upper Pole into the Lower Pole, using the Knob and
Connecting Hardware.
3. Mount the Motor on Upper Pole with a Screw.
4. Fasten the Rear Guard with the Motor using a Washer and Nut.
5. Fix the Fan Blade into the Motor shaft with a Screw.
6. Combine the Front Guard with the Rear Guard with a clip.
WARNING
DO NOT depend upon the On-Off switch as the sole means
of disconnecting power when installing or servicing the 30"
Oscillating Pedestal Fan. Always unplug the power cord.
CARE AND MAINTENANCE
Unplug the appliance before cleaning. Don’t use water for
cleaning metal surfaces. Using a soft cloth wipe off the
surfaces of the fan. In order to remove the dust from the grill,
use a vacuum cleaner or remove the front grill by removing
the securing screw on the edge of the grill with a screwdriver.
After cleaning, remount the grill. Then fasten the securing
screws on the edge of the grill.
OPERATING INSTRUCTIONS
1. Adjust the desired speed by pulling the chain switch
(Stop – Low – Medium – High).
2. To adjust the airflow upward or downward, tilt the 30"
Oscillating Pedestal Fan head to the desired angle. Loosen the
tilting knobs on both sides of the fan head. Tilt the fan head to
the desired position and tighten the knobs back in place.
NOTE:
It is normal for the motor to feel warm to the touch during
operation. The motor is thermally protected and will automatically
shut off when it overheats. If this happens, immediately disconnect
the fan from the power outlet.
OSCILLATION INSTRUCTIONS
CAUTION
Switch the fan to the OFF position before adjusting the oscillation.
NOTE:
There are 2 different holes in which screw will fasten.
Operating Oscillation
Non-Oscillation