4
Operating Instructions and Parts Manual
24492
20V MAX* LI-ION CORDLESS
ANGLE GRINDER
11/18
2018 OEMTOOLS
™
DISPOSAL
At the end of the useful life of the OEMTOOLS
®
20V
MAX* Li-Ion Cordless Angle Grinder, dispose of the
components according to all state, federal and local
regulations.
BATTERY DISPOSAL
Exposure to high temperatures can cause the batteries
to explode; do not dispose of in a fire. Some countries
have regulations concerning battery disposal. Follow
all applicable regulations. Return used batteries to a
collection location for recycling. Call 800-822-8837 or
visit www.call2recycle.org to find a collection location.
PURPOSE
The OEMTOOLS
®
20V Max Li-Ion Cordless Angle
Grinder delivers 10,000 RPM for the most demanding
applications including grinding, polishing, cutting and
sanding.
PRODUCT SPECIFICATIONS
Voltage:
20V MAX*
Speed:
10,000 RPM
Max. Disc Diameter:
4-1/2"
Spindle Thread:
5/8"
Spindle Lock:
Yes
Min. Disc Thickness:
1/4"
Weight:
7.97 Lbs.
Battery:
4.0Ah Li-Ion
Charge Time:
2 Hrs.
INSTRUCTIONS
ASSEMBLY AND OPERATION
WARNING
Always disconnect your angle grinder from the power
source when replacing grinding or cut-off discs,
adjusting the guard, cleaning the tool or when the
tool is not in use. Disconnecting the angle grinder will
prevent accidental starting that could cause serious
personal injury.
INSTALLING THE AUXILIARY HANDLE
1. Unplug the angle grinder from the power source.
2. Install the auxiliary handle (1) by screwing it
clockwise into the left side (2) of the gear housing
(3) (Fig. 1).
NOTE: The handle can be installed in two different
positions; left side or right side (Fig. 3 and 4).
WARNING
The auxiliary handle must always be used to prevent
loss of control and possible injury.
3. Tighten the auxiliary handle securely.
NOTE: Hand tighten the auxiliary handle. DO NOT over
tighten.
1
Fig. 2
Fig. 5
Fig. 1
Fig. 3
Fig. 4
Fig. 7
Fig. 1
INSTALLING THE GUARD
WARNING
The guard must be installed before installing a grinding
disc or using the angle grinder. Failure to do so could
result in serious personal injury.
1. Pull the guard clamp lever (1) outward to allow the
guard clamp to expand for installation.
2. Slide the guard clamp (2) over the spindle housing
(3) until the blade guard locating detents (4) mate
with the grooves (5) in the spindle housing (Fig. 2).
1
Fig. 2
Fig. 5
Fig. 1
Fig. 3
Fig. 4
Fig. 7
Fig. 2
3. Press the guard clamp fully onto the spindle
housing.
NOTE: Rotate the guard so it is positioned correctly
depending upon the location of the side handle in
Fig. 3 and 4.
4. Push the guard clamp lever toward the guard
clamp until the guard clamp firmly locks the guard
onto the spindle housing.
