4
Operating Instructions and Parts Manual
24456
SMART JUMP CABLES
IMPORTANT SAFETY INSTRUCTIONS
The warnings, precautions, and instructions discussed
in this manual cannot cover all possible conditions
and situations that may occur. The operator must
understand that common sense and caution are
factors which cannot be built into this product, but
must be supplied by the operator.
DISPOSAL
At the end of the useful life of the OEMTOOLS
Personal Power Source, dispose of the components
according to all state, federal, and local regulations.
PURPOSE
The Smart Jump Cables are intelligent cables that
verify proper connection, making jump starting safe
and easy.
GENERAL SAFETY
1. Always make sure the blue plug of the jumper
cable is fully engaged in the jump start socket
before jump starting the vehicle. This can limit the
available power and may cause damage or melting
of the blue plug.
2. Always make sure jumper clamps are well
connected, check if the vehicle’s battery
connections are rusted or dirty and if necessary,
clean before jumping start the vehicle.
3. DO NOT attempt to jump start more than 3
times. Otherwise, it can damage the OEMTOOLS
Personal Power Source. If your vehicle will not
start, check for other problems.
4. DO NOT connect the two clamps. Otherwise, it
may be dangerous!
5. DO NOT disassemble the OEMTOOLS Personal
Power Source. Otherwise, it may be dangerous!
6. DO NOT put fi ngers or hands into any of the
unit’s outlets.
7. DO NOT expose the unit to rain or snow.
8. Never place the unit directly above battery
being jumped.
9. DO NOT use the unit to jump start a vehicle while
charging the internal battery.
10. DO NOT permit the internal battery of the unit to
freeze. Never charge a frozen battery.
11. Consider having someone nearby to come to your
aid when you work near a lead-acid battery.
12. This power source is not intended for use by
young or infi rm persons without supervision.
13. DO NOT use as a toy.
14. DO NOT allow the power source to become wet.
15. DO NOT immerse power source in water.
16. DO NOT operate the power source in explosive
atmospheres, such as in the presence of
fl ammable liquids, gases or dust.
17. DO NOT expose the power source to heat. Do
not store in locations where the temperature may
exceed 70°C.
18. Charge only at ambient temperatures between
-5°F ~ 140°F. Charge only using the charger
provided with the power source.
19. At the end of their useful life, discard the power
source with due care for our environmentCharge
only using the charger provided with the
OEMTOOLS Personal Power Source.
20. Under extreme conditions, battery leakage may
occur. Carefully wipe the liquid off using a cloth
and avoid skin contact when you notice liquid
on the batteries. In case of skin or eye contact,
rinse immediately with clean water and seek
medical attention.
21. DO NOT attempt to jump start Diesel Engines.
22. Never leave the jumper cables connected to the
Personal Power Source when storing.
Size
14” x 1.5” x 1.5”
Weight
0.5 Lbs.
Power Source
80000 MaH
Operating Temperature -5°F ~ 140°F
PRODUCT SPECIFICATIONS
11/14
2014 ©OEMTOOLS