OEC DAB BD-750, Инструкция по установке, эксплуатации и обслуживанию

Страница: 5 / 14

pg. 5
6 Warnings
6.1 Skilled Technical Personnel
It is advisable that installation be carried out by skilled personnel in possession of
the technical qualifications required by the specific legislation in force.
The term skilled personnel means persons whose training, experience and instruction,
as well as their knowledge of the respective standards and requirements for accident
prevention and working conditions, have been approved by the person in charge of plant
safety, authorizing them to perform all the necessary activities, during which they are
able to recognize and avoid all dangers.
6.2 Safety
Use is allowed only if the electric system is in possession of safety precautions in
accordance with the regulations in force in the country where the product is installed.
The pump should not be handled while connected to an electrical supply.
6.3 Preliminary Inspection

Unpack the pump and check its integrity and all of its components.

Check the data on the nameplate to make sure it corresponds with power supply, and
the original requirements.

In the case of any discrepancies contact the supplier immediately.
6.4 Responsibility
The Manufacturer does not vouch for correct operation of the pumps if they are
tampered with or modified, run outside the recommended work range or in
contrast with the other instructions given in this manual.
The Manufacturer declines all responsibility for possible errors in this instructions
manual, if due to misprints or errors in copying. The company reserves the right
to make any modifications to products that it may consider necessary or useful,
without affecting the essential characteristics.
7 Installation
7.1 Installation General
Installation and use should be compliant with ISO 22241 and PEI recommended practice
1100-10. Consult these standards for last updates. Installation should also comply with
all applicable Federal, State, Local, or Provincial construction, safety and environmental
codes and regulations. OEC Fluid Handling, Inc. declines any responsibility in case of
accidents or damages caused by improper use of the pump product or due to negligence
or lack of observance of the instruction described in this booklet or use of the pump
under conditions that differ from the rating on the nameplate.
Installation is safety relevant, and therefore must be carried out by an expert and
authorized installer, by regulations issued by the competent authorities and dictated by
experience and common practice.