CHARGING THE GALAXY SEEKER II DRONE AND MONITOR
X-GUARD INSTALLATION (if not installed from factory)
SETUP OVERVIEW
RADIO CONTOL TRANSMITTER • BATTERY INSTALLATION
If the Radio Control Transmitter will not be used
for extended periods of time, please remove the
batteries.
Please use 4 AA batteries. Use
the polarity markings to install
in the correct orientation. Do
not mix batteries of different
types.
Unscrew the screw
holding the battery lid to
the body. Then lightly pull
the clip down to pull the
lid away from the
transmitter body.
Insert 4xAA batteries into
the battery compartment,
making sure to match the polarities. Then replace the lid and
firmly tighten the screw to secure the battery compartment.
NOTICE
Attack the X-Guards to the end of each rotor using the included small screwdriver. Place the small plastic round tabs into the holes on each rotor arm. Firmly
tighten the screws. The center bar of the guard should line up with the arm of the rotor. Once each X-guard is installed. Turn the propeller to make sure that it
doesn't doesn't hit the X-Guard. If it does, carefully bend the rim of the X-Guard away from the propeller until the propeller can spin freely without obstruction.
1. Locate the battery compartment lid under the rear fin on the bottom of the Drone. Push the latch to open the lid.
2. Gently pull out the red-and-black connector. Grasp the shorter red connector while holding the larger red end of the connector.
Without tugging on the wires, carefully unplug the shorter red connector.
CAUTION: Battery may be hot if being disconnected right after use. If hot, then wait a few minutes to let the battery cool down.
Please check the AA batteries routinely. If the AA
batteries are left within the Radio Control Transmitter,
potential leakage and/or corrosion may occur, which
can damage the transmitter and create a fire hazard.
Attach the X-Guard propeller defense system.
STEP 1
Install batteries into the radio control transmitter.
STEP 2
Charge the Galaxy Seeker II and monitor.
STEP 3
Attach the monitor to the radio control
transmitter when charging is complete.
STEP 4
CAUTION
WARNING
