ODSIF Luxury roller blind system, Руководство пользователя

Страница: 5 / 16

5
SYSTEM INSTALLATION
3. System installation
Make sure there is enough space for the assembly of the product. The tools required
for the installation of the product are electrical drills with 6-8 mm diameter drill bits
(for concrete wall or ceiling),
fi bre-measuring tape, cross head screw driver, hand saw
and a pair of scissors.
3.1 Measuring and cutting of tube length
The tube should be cut into proper length. There are two methods for installing the
blind system..
Inner installation: The roller blind is installed insde a window, the tube length should
be 3 cm less than the window width. (See
fi gure next page).
Outer installation: The roller blind is installed over the actual window covering the
whole surface of the window and its glass; the tube length should be at least 7 cm
longer than the window width (See
fi gure next page).
Measure the correct length for the tube and cut the tube by handsaw. Please, note that
the edges of the cut tube should be perfectly straight, and clear of any
fi lings.
3.2 Wall/ceiling installation
The system is designed to be installed on the ceiling or wall. The package comes with
rawl plugs and screws. If applying your unit onto a wall made of plaster boards rather
than brick or solid wall, please use special plaster board’s plugs.
Please note: The brackets should be mounted on the same surface and in straight
line. you must leave a suf
fi cient gap between the wall and the brackets (See fi gure
next page).