O'Donnell Z01B, Руководство по сборке

Страница: 7 / 36

7
3
SPUR/DIFF GEARS
HARDWARE
7 7 7
4
DIFF OIL
HARDWARE
Fill the diff until the planetary
gear shafts are completely
covered with diff oil. When
using heavy oils, you need to
allow the oil to settle and add
oil if necessary. Do not overfi ll!
(
Note: See set-up sheet for
recommended diff oils.)
Finish tightening the diff
gear screws in order. This
will help make sure the gear
is mounted fl at on the diff
housing and the housing is
properly sealed.
1
2
3
4
Make sure the bearing is
fully seated on the gear.
Front/Rear x2
Center
Apply a small amount of the included
grease to the O-ring before installing.
This will help prevent damage to the
O-ring when installing the drive joint.
D
IF
F
O
IL
DIFF OIL
Diff Outdrive O-Ring
Sun Backing Washer
8x16mm Bearing
3x12mm FH
Screw
(x3)
(x3)
(x3)
(x12)
Grease
Grease
1
1
Build the front, rear and center diffs.
Apply grease in the groove
and a light fi lm of grease
on the shaft of all outdrives.