In order to ensure a good user experience, it is necessary to initialize the
minimum height when using it for the first time. Press the down key to the
lowest position, then press and hold the down key for 3 seconds, and
release it after the display (Reset). The table starts to run down to the
end and bounces to a certain height, the reset is completed and the minimum
altitude is displayed.
In the "E10, E20, E60" alarm state or after running to the lowest height position, press and hold the
down
key for 3 seconds, release it after the display (Reset), the lift table starts to run
down to the end and bounces to a certain height, thereset is completed and the lowest height is
displayed .
To make your desk higher and archive the proper height of the standing desk,
press the up key until it reaches the desired position. On the opposite, to
make your desk lower, press the down key until it reaches the desired
position. The keyboard has a screen to show the height from the desktop to
the floor.
To save a position, adjust the desk to the desired height. Press the button,
the screen will flash. Press to save the position. Use subsequent numbers,
such as and to save more positions.
Note: If there is no number key pressed within 6 seconds, it will exit the
memory mode.
Adjusting the Height
Saving the Desk Position
Press any button to wake up the keypad screen
Screen Wake
Exceptional Initialization
Initialize Settings
07
06
Troubleshooting
Code
Over Hot Protection
This feature is triggered when the desk is in the
movement for extended periods of time.
Please stop the adjustment and use the desk after reboot
orat least 20 minutes.
Please power off the desk. Recheck to make sure the
connection between motor and controller is reliable,
then power on again.
Motor Abnormal Function
Overload Protection
Under Voltage Protection
Over Voltage Protection
Missing Step
Please remove heavy objects on the desk when the
desk is running upwards. Cut off the power and
remove heavy objects on the desk when the
desk is running downwards.
Please cut off the power and recheck to make sure
the connection between motor and controller is
reliable, then power on again.
Please cut off the power and recheck to make sure
the connection between motor and controller is
reliable, then power on again.
Please cut off the power and re-check and make
sure all channel motors are exactly the same and
their connection to the controller is reliable,
then power on again.
Description
Block Protection
This feature is triggered and movement is stopped
when the desk experiences vibrations, bumps, or
tilts during movement.The protection mode will
be automatically released when reverse the
adjustment.Then, check to ensure that the desk
does not vibrate significantly, bump into obstacles
or tip over during height adjustment.
Troubleshooting Solution
3
2
1
s
Initialization
S
1
2
3