OCULUS 54300, Инструкция по эксплуатации

Страница: 19 / 28

10 Transport and Storage
Instruction Manual SDI® 4 (G/54320/EN 0220 Rev01) 15 / 24
9.3 Sterilization of the Rubber Cap
If you are using the rubber cap for the star knob, it must be sterilised first.
The rubber cap for the star knob of the SDI® 4 can be autoclaved with
steam (max. 134°C); also refer to the
Conditioning Manual .
10 Transport and Storage
Attention
Equipment damage due to improper transport and storage

Transport the SDI® 4 with care.

Store the SDI® 4 in compliance with the transport and storage
conditions, the national regulations and the regulations of your
hospital. Also see
sect. 15, page 20 .

Avoid impacts when moving the SDI® 4 to another location, since
this can have an adverse affect on the adjustments.

With the use of the transporting lock for star knob you position the
optical system of the SDI® 4 in the rest position. Only then the
position is fixed.

Check the unit and its accessories for damage after every transport.
11 Troubleshooting
Attention
If a fault occurs which you are unable to correct by following the
instructions below, label the device as “out of order” and contact our
service department. (Address:
sect. 12.2, page 18 ).

Never operate a damaged SDI® 4.