Title: User Manual SmartDiag2GO GD201-O
Rel: 1.1
Pag.
4
a
5
Device fixing rules:
Fix the Octo device with double sided adhesive and plastic ties
where necessary to reinforce the fixing
in the chosen location, taking
care to:
-
Fix it properly on a structural part of the chassis (i.e.: the metallic dashboard structure) where it can detect the real
movements of the vehicle and not independent vibrations (avoid plastic air duct or weak plastic parts of the vehicle)
-
Avoid to shield the internal GPS antenna, leaving enough room around the device top side to allow GPS detection
-
Fix the device applying the double-adhesive tape to the correct surface (see image)
Fix it carefully in a way in which it cannot detach and create danger for the drive.
The cables must in both cases be routed and secured in a way in which they do not disturb the driver and must be hidden.
The cables must be installed in a way in which they do not interfere or pass around the device itself.
The double adhesive must be used in an environment which temperature is not below 21°C or above 38°C.
Before applying the double adhesive clean the surfaces with isopropyl alcohol, the press the device on its location for at least 1
minute to ensure the adhesion.
ACTIVATION AND DIAGNOSIS PROCEDURES
If the device is not associated to an Octo voucher: perform the association procedure of the IMEI code of the device to the Octo
voucher before installing it (ask to the customer care for indications).
If the device is already associated to an Octo voucher: verify the device IMEI code/plate code association.
Install the device in the OBD port, verify that the LEDs are blinking and wait 5 minutes.
To allow the vehicle identification to be completed, turn on the engine, wait 5 minutes and then turn off the engine for 5 minutes
and then repeat the steps (turn the engine on for 5 minutes and then off for 5 minutes).
During this installation procedure it could happen that the MIL and other signal lamps on the dashboard are switched on: that is
normal.
At the end of the procedure, switch on the engine again and verify that the dashboard does not show any signal lamp, otherwise do
the following steps: turn off the engine for 5 minutes and turn it on and check again.
If the signals on the dashboard are still on, disconnect the device and contact Octo technical assistance.
The blinking mode for correct installation is: blink (one or two or three)
–
stop (few seconds)
–
blink -
…
The correct activation of the device must be verified on the Octo portal.
NOTE
: the procedure requires that the vehicle is outside in an open area to have a good cellular signal and the possibility of satellite
reception. Check that the terminal has been correctly associated with the contract.