Page 11
Copyright© 2011 Octet Matrix Audio
DWT4416/DWT4824 Transmitter Mounting
If you choose to mount the transmitter, print out this page. Make sure that Page Scaling in
the print settings is set to “none”. Use a nail, screw tip, or other sharp object to mark the wall
or other mounting surface by puncturing the paper at the two crosshairs.
If the planned mounting space is tight, use scissors to cut around the template outline and
position the template exactly where the transmitter will be mounted. Puncture the paper at
exactly the location of the screws (instead of at the crosshairs) or the transmitter outline will
shift up to an inch from the expected location.
If you cannot locate a stud to screw into, drill a ¼” hole at each marked location and tap in
screw anchors. Fasten screws to a stud or anchors leaving approximately ” gap between the
wall and the bottom of the screw head.
