oConnor 2560, Руководство пользователя

Страница: 10 / 28

8
Installation
Mounting the head
The 2560 is installed onto standard tripods using either the Mitchell
base and tie down or the 150mm ball base and tie down as required.
Levelling the Head
After securely mounting the head on to the tripod, center the bubble
level to set the level.
If necessary, in poor light conditions:
1.
Press the button illumination bubble (the light will remain on for 20
seconds).
2.
Press the button again within 20 seconds to turn the light off.
Ball Base
Loosen the bowl clamp. Move the fluid head to center the level bubble.
Tighten the bowl clamp and re-check the level.
Mitchell Base
Levelling is achieved by adjusting the legs on the tripod until the level
bubble is centred.
WARNING! Do Not fit a head to a tripod that cannot support
the combined mass of the head and its full payload.
WARNING! If required use a mid-level or floor spreader to
ensure that the tripod legs are spread sufficiently; this ensures
that the C of G remains within the footprint of the tripod.
Refer to the tripod instructions supplied with the tripod for
correct fitting procedure.