Ochsner AIR 80 C13A, Инструкции по эксплуатации и монтажу

Страница: 15 / 68

BA_AIR_80_C13A_AIR_80_C22A_OTE3_SW5x_EN_V07.docx Page 15 of 68
4.8.5 Sizing the connection pipework
Fig. 20: Pipework lengths and max. height difference between the heat pump and the evaporator: Case 1
Valid for AIR 80 C13A and AIR 80 C22A
Fig. 21: Pipework lengths and max. height difference between the heat pump and the evaporator: Case 2
Valid for AIR 80 C13A and AIR 80 C22A
Sizing the connecting pipework in Case 1 (Fig. 20) and in Case 2 (Fig. 21):
•
The sum of the partial lengths (s1+s2+s3+....) must not exceed a total length of 16m !
•
Fluid pipework: Cu, 22x1mm:
•
Suction gas pipework: Cu, 42x2mm
•
Max. number of bends: 8 (to be manufactured on bending equipment, at 42mm is 90°-solder fitting to
be used)
•
Bending (22mm raw copper) radii of 1 m are deemed to be straight!