Document UT-MT-0779_EN
Page 35 of 37
Edition 23/04/2019
Supersedes edition 06/03/2019
LED INSET RUNWAY EDGE LIGHT LIRE
INSTRUCTION MANUAL FOR USE, INSTALLATION AND MAINTENANCE
normal operation of the fixture it’s necessary to replace the LED board and unlock
the monitoring device. For this operation it is necessary to follow these steps:
remove the fixture from the base and open it following instructions of “Removing
and Opening the Light Unit From the Base”
replace the LED module following instructions of “LED Module Replacement”
restore the condition of proper functioning of the monitoring device as shown in
Figure 27
Reassembly the fixture following instructions of paragraph “Closing the Fixture”,
“Leakage Test” and “Reinstalling the fixture”.
Figure 27 - Restoring the Monitoring Device
