Document UT-MT-0779_EN
Page 33 of 37
Edition 23/04/2019
Supersedes edition 06/03/2019
LED INSET RUNWAY EDGE LIGHT LIRE
INSTRUCTION MANUAL FOR USE, INSTALLATION AND MAINTENANCE
4.8.2
O-Ring replacement
Remove the old O-Ring from the groove and clean the flange mating surfaces and the
groove, scraping carefully. Take care not to damage the mating surface and the
bottom and sides of the groove. Position it in the centre of its groove and push it
inside.
NOTE 1: Make sure that the proper O-Ring is re-inserted into the groove.
NOTE 2: The seat of an O-Ring gasket is dimensioned to allow the proper
positioning when compressed between the mating surfaces. Screws properly
tightened are important in obtaining a complete seal.
TIGHTENING TORQUE
lower cover flat CSS TORX M5x16
2.5 Nm
fixture locking screw
35 Nm (for shallow base)
35 Nm (for L-868 base, size B)
4.9
CABLE LEAD WITH PLUG
4.9.1
Removing the cable lead with plug
Remove the fixture from the base and open it following instructions of “Removing
and Opening the Light Unit From the Base”.
Inside the lower cover, disconnect the pair of wires from the electronics by cutting
the cables, unscrew the gland and pull out the cable lead with gland gasket.
4.9.2
Installing the new cable lead with plug
Insert the gland nut on the new unipolar cable lead so that the length of the cable
outside the fixture is 46cm (Figure 25 – n° 2).
Splice the ends of the cables for a length of approx. 7mm (Figure 25 – n° 3).
Tighten the gland nut at 6Nm.
Restore the electrical connections by faston terminals.
Figure 25 - Cable Lead With Plug
