OCEM 3 Series, Руководство по эксплуатации и обслуживанию

Страница: 21 / 46

INST
ALLA
TION
UT-MT-0972_1.0_19-09-2022 (EN)
Use and Maintenance Manual
LED PAPI 66
21
Position the LHA unit on the supports suitably fixed to the ground and insert the alignment washer (3a) and the
increased washer (3b). Screw, without tightening, the upper nut (3c).
If on the support surface of the tool there is dust or dirt, carefully clean the surface before
proceeding.
Position the clinometer on the front transverse tubular in centred position. Act on the lower nuts (3c) and (3d) of
the front supports to adjust the alignment (0°) of the unit.
Position the clinometer on the rear support bracket, by fastening it with 2 knurled screws (supplied with the
clinometer). Act on the lower nuts (3c) and (3d) of the rear support to adjust the tilt angle (i) of the unit.
Adjust each unit according to the installation parameter provided (in compliance with the
tolerance values indicated).
#
i [°]
standard
runway
1
3° 45’ (2,75°)
2
3° 15’ (3,25°)
allowed tolerance:
+3’ (+0,05°)/-0’ (-0,00°)
#
i [°]
standard
runway
large runway
with ILS
1
2° 30’ (2,50°) 2° 25’ (2,42°)
2
2° 50’ (2,83°) 2° 45’ (2,75°)
3
3° 10’ (3,17°) 3° 15’ (3,25°)
4
3° 30’ (3,50°) 3° 35’ (3,58°)
allowed tolerance:
+3’ (+0,05°)/-0’ (-0,00°)