SPORTS SERIES
Single / Dual / Colours / DMX
.
INSTALL & OPERATION MANUAL
18
4
Operation / Maintenance
4.1 SINGLE COLOUR STROBE
To enter strobe mode, toggle the power on and off quickly twice, then back on. They should now strobe in
a pseudo-random pattern. The lights can be reset from strobe mode after 20 seconds of use by simply turning the lights
off and then back on again.
4.2 DUAL COLOUR OPERATION
The Dual colour change has seven modes of operation:
1. Solid White
(default stage after power cycling)
2. Solid Blue
3. Fade between White and Blue
4. Random Strobe White
5. Random Strobe Blue
6. Random Strobe White / Blue
7. 50% White and 50% Blue
To cycle between the above modes, turn off the light for less than 1 second, then back on again.
NOTE: Fade mode is not guaranteed to stay in sync between lights over time.
4.3 SPORT DUAL COLOUR CONFIGURATION MODE
Enables selection of either white or blue colour as default at power up.
To enter configuration mode:
1. Turn on light(s)
2. Wait around 1 second (or until light(s) illuminate)
3. Turn off light(s)
4. Wait for a minimum of 5 seconds then turn light(s) back on again.
5. Repeat steps 2-4 another 4 times. (If the light changes mode on re power up then the light has not been
turned off for long enough in step 4)
6. On the 5th power up, the light(s) should enter the configuration mode
–
this will be confirmed with a
sequence of five blue/white flashes followed by a steady white (the steady colour indicates the default
start up colour).
