EXPLORE
E7
2 0 1 9 I N S T A L L & O P E R A T I O N M A N U A L
23
EXPLORE SERIES
PROBLEM
CHECK
CAUSE
FIX
Light does
not look
bright
Check that there is no
marine growth on the
lens
Marine growth
Clean the lens as per
maintenance advice
Check voltage supply to the
light is between 11V and
32V DC (The light will still
work between 10 and 11
volts however at reduced
brightness)
Voltage is either too
high or too low
Investigate reason for high
or low voltage and fix
Check voltage supply is
stable and does not
fluctuate
Voltage is
fluctuating
Investigate reason for
voltage fluctuation and fix
Check that the electrical
connections between the
light and the supply cable
have been made correctly
and recommended cable
gauge has been used
Poor electrical
connection
Remake connection and
seal joint correctly
Confirm all LEDs are
illuminated
1 or more LEDs are not
working
Contact your dealer.
Check lights to see if water
is present inside the light
Water present
Contact your dealer.
Check cable connections for
corrosion
If corrosion is
present
It is not advised to reuse the
cable if water is present
inside. Contact your dealer
for a replacement. This is
NOT covered by the warranty
Light has
water
inside
Check integrity of lens
Light will require
replacing
This is not covered by the
warranty - Contact your
dealer for a replacement
light. Only use genuine
OceanLED parts
Check connections to make
sure they are not
submerged in water
Light will require
replacing
This is not covered by the
warranty
Check cable to make sure
there is no damage to the
cable
Cable will require
replacing
This is not covered by the
warranty. Only use genuine
OceanLED parts
Checked all factors that
are above, and the light
still does not work
Light faulty
Contact your dealer for a
replacement light
