- Minimum pressure: 1 bar / maximum: 5 bars (beyond, install a
pressure reducer).
- Make sure that the supply pressures for hot and cold water are
well balanced.
- Recommended temperature for adjusting the hot water
installation: 60 ° C (maximum: 80 ° C)
- Minimum cold water temperature: 10 ° C (a lower temperature
would damage your tap). Very hard water is heavily loaded with
lime stone which accelerates the scaling of your taps.
Treating your water with a softener helps protect your facilities and
extend the life of your equipment.
Terms of use
- During assembly, the connection threads must not be damaged
(it must be easy to screw the nuts on the threads).
- Place a silicon ribbon on the offset male-male connectors to
ensure the watertightness, then screw them into the hot and cold
water supply hoses inside the wall and make them correspond to
the distance between the connectors of the mixer. Check the level
of the connectors during the fastening, it must be horizontal.
- Place the cover cups on the connectors.
- Place the gasket into the female connectors of the mixer before
to proceed to the tightening.
- When using for the first time, make sure that your product is
working (in particular that the water flows at the right temperature
and with the right flow rate).
NB : For the fitting to your installation: tighten the fitting or the nuts
securely using a wrench. Avoid excessive tightening, which could
break the thread or cause micro cracks which could expand over
time and the pressure of the water and cause a leak.
Installation
The proper functioning of the bathroom mixer requires regular
maintenance.
We therefore recommend:
·
never use abrasive or corrosive products. These aggressive
products attack coatings and tarnish your faucet.
·
clean the chrome surface using a mild soap or soapy water and
a soft cloth making sure to rinse well with clean water after
cleaning.
·
activate the moving parts (lever) at least once per week to
ensure smooth operation over time
Maintenance / cleaning
Before handling, make sure that all components are present and
visually check their good surface condition.
When mounting and / or installing, make sure that by respecting
any instructions, you do not experience any difficulty in screwing,
tightening, fitting.
Unpacking
