Ocean Technology Systems PowerCom Surface Station 3000S, Руководство пользователя

Страница: 17 / 32

O
TS PO
WER
CO
M
SURF
ACE
11
Maintenance
Routine maintenance of the PowerCom Surface Station (3000S & 5000S) units is
necessary to ensure an extended life of the equipment. Failure to properly care
for and maintain the PowerCom Surface Station (3000S & 5000S) and ancillary
components could lead to flooding of the units, damage to the connectors, trans -
ducers, housings and other failures. If any of this equipment is found to not be
functioning as described in this manual, contact the Ocean Technology Systems
service department or authorized retailer.
Maintenance Intervals
Part Cycle
Battery 2 years or 300 Charge cycles
Housing Lid and Base O-ring 2 years
Cable As Required
Transducer As Required
PRE-DIVE CHECKLIST FOR ESTABLISHING
COMMUNICATIONS
1. Fully charged battery.
2. Ensure everyone is on the same Channel.
3. Perform visual inspection.
4. Are Panel screws fully tightened?
5. Are Connectors and pressure relief valve free from debris and salt?
6. Is the unit on a secure / level surface?
7. Confirm Transducer Cable assembly is secured to a cleat or similar, is free
from boat props, obstructions, and is not dragging or resting on the bottom
8. In-water surface check:
a. Divers should recheck the location of the earphones.
b. Establish communication with divers and/or surface station.
POST DIVE PROCEDURE
1. Dry the unit and rinse down the transducer with fresh, clean water.
2. Wipe the panel with a damp cloth as necessary to remove salts, dirt and
debris. Ensure pressure relief valve is free from salts, dirt and debris.
3. Ensure panel and controls are dry before closing case.
4. Dry all components and store in a dry, safe area.
5. Similar maintenance should be performed on all ancillary equipment.