Connecting the OMX-VGDA1x4 1:4 VGA/UXGA Distributor
3
5 Connecting the OMX-VGDA1x4 1:4 VGA/UXGA Distributor
To connect the
OMX-VGDA1x4
1:4 VGA/UXGA Distributor
, as the
example in Figure 3 illustrates:
1. Connect a computer graphics source (for example, a computer) to the INPUT
HD15F connector.
2. Connect the OUTPUT HD15F connectors to up to
1
four acceptors (for
example, display 1 to display 4).
3. Connect the power cord
2
(not shown in this illustration).
4. Adjust
3
the EQ. cable compensation equalization level, if required.
5. Set the ID BIT Control switches 4 and 11 on the underside to ON (by sliding
them to the left). This would enable a notebook or laptop (if connected instead
of a computer) to output an UXGA signal to an external VGA monitor.
Figure 3: Connecting the OMX-VGDA1x4 1:4 VGA/UXGA Distributor
1 When not all outputs are required, connect only the outputs that are required and leave the other outputs unconnected
2 We recommend that you use only the power cord that is supplied with this machine
3 Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level
Содержание OMX-VGDA1x4
Страница 1: ...OMX VGDA1x4...
