background image

1x6 Video & Stereo Audio
Distribution Amplifier

OMX-MDA6

800 Kings Highway • Saugerties, NY 12477

A Division of Tower Products, Inc.

If the OMX-MDA6 is the only DA in your system,
you must terminate the video input with a 75

ter-

minator (installed on unit). Without proper termi-
nation of the OMX-MDA6 will not function proper-
ly. Feed the video signal into the unit by connect-
ing to the BNC input. Terminate the other BNC
connector in the input section if the OMX-MDA6 is
being used as a single unit. The Diagram at Right
shows a basic setup using a Master VCR distribut-
ing a signal to two other VCRs.

Note: There is no need to terminate audio
connectors.

If the OMX-MDA6 is one unit in a series of DAs
(bridging), then the other BNC in the input section
that has the terminator in place is used to “loop” to
the inputs of the other DAs. You must remove the
terminator from each DA that is looping to another.
The last DA in the chain must be terminated. See
sample Diagram at Right.

L

OOPING

DA

S

I

N

A S

ERIES

I

NPUT

T

ERMINATION

The OMX-MDA6 is shipped from the factory already calibrated and ready to use. There is no need for
any customer adjustments for normal use of the unit. There are, however, certain procedures that must
be observed to assure proper performance of the unit in your system.

G

ENERAL

O

PERATION

75

75

Master Video Out
to OMX-MDA6 In

Master Audio Out to Input

Master Source

Master Video Out
to OMX-MDA6 In

Master Audio Out to Input

Master Source

Отзывы: