background image

 

2

 

 
 
 
2_Rudder Tubing: 

1.  There will be a total of 4 tubing holes through 

which the steering lines will run.  You will find 
2 vertical notches at the rear of the foot well 
ledge and 2 vertical notches at the stern of 
the kayak.  Using a 3/8” drill bit, drill straight 
into the vertical surface of these notches.  
Drill into the center of these notches, being 
careful not to drill too high where the notches 
narrow.  See 2.1 & 2.2  

 
2.  Insert the 4 rubber grommets into each of the 

drilled holes. Using scissors, cut the ends of the tubing at an angle to make inserting the 
tubing easier. 

3.  Straighten a coat hanger (or use another length of straight 

wire), and insert it through the tubing to keep it straight as you 
are inserting it. 

4.   Spray the tubing with soapy water (or another lubricant) and 

insert it into one of the footwell grommets. Continue pushing 
the tubing through the grommet, keeping it in the space 
between the tankwell and the outside wall of the kayak.  
(Tilting the boat to the side that you are working on may help 
keep the tubing in place.) See 2.3 

5.   Spray tubing with lubricant as needed. 
 

6.  Reach inside the stern access hole to pull the tubing through the hull and 

guide it through the stern grommet.  .  Hold your fingers over the grommet 
as you pull the tubing through so the grommet stays in place. Remove the 
wire. See 2.4 

7.  Pull tubing taut.  Rub the tubing immediately in front of the grommets with a 

dry cloth to remove the lubricant and finish, creating a dull, sticky area.  
Position the tubing so the dull part is at the grommets.  This will prevent the 

tubing from sliding through the grommets.   

8.  Pull tubing taut.  Cut tubing 1” from grommets on both ends. 
9.  Repeat for other side. 

 
 
3_Install Foot Rail Assemblies: 

1.  Place one rail assembly on the ledge above the foot well making sure the 

pedal is toward the bow of the boat.   

2.  Note how the two pre-drilled holes in the track line up with 

the brass screw inserts on the boat.   

3.  Using two ½” screws and washer sets, attach track to boat 

using the inserts.  Do not over-tighten! See 3.1 & 3.2 

4.  Repeat for other track. 

 
 
 

 

 

Footwell 

Stern 

2.2

2.1 

2.3

2.4 

3.2

3.1

Отзывы: