AS-
Room temperature sensor error.
HS-
Electric heating sensor error.
● - Evaporator temperature sensor error.
- Unplug the unit and plug it back in. lf the error
repeats, call for service.
NOTE:
"
●
"
is displayed as shown in the left diagram.
- Unplug the unit and plug it back in. lf the error
repeats, call for service.
NOTE: In Fan Only mode, it will display
"LO"
or
"
HI
"
.
- Unplug the unit and plug it back in. lf the error
repeats, call for service.
Now that you have mastered the operating procedure, here are more features in your control that you should
become familiar with.
The Cool circuit has an automatic 3 minute time delayed start if the unit is turned off and on too abruptly.
This prevents overheating of the compressor and possible circuit breaker tripping. The fan will continue to run
during this time.
The unit can show the temperature in Fahrenheit or Celsius.
To convert from one to the other, press and hold the LEFT and RIGHT TEMP/TIMER buttons at the same time
for 3 seconds.
The louvers will allow you to direct the air flow UP
or DOWN (only on some models) and Left or Right
throughout the room as needed. Pivot horizontal
louvers until they are in the preferred direction.
Move the Levers from side to side until the desired
LEFT/RIGHT direction is obtained.
Shows the set temperature in
"
°C" or
"
°F" and the
AUTO-TIMER settings. While in Fan Only mode, it
shows the room temperature.
