OBID
®
classic-pro
Installation
ID CPRPOS
FEIG ELECTRONIC GmbH
Page 14 of 18
ID CPRPOS User Manual-01.doc
6. Installation of a Secure Access Module (SAM)
To install a secure access module (SAM) the bottom part of the housing has to be opened. After
removing the 4 screws the bottom part of the housing could be opened.
Figure 10: Opening of the housing
A socket is located on the PCB in which the SAM can be plugged in. To open the socket the cover
of the socket has to be pushed slightly in direction “OPEN”. Afterwards it can be lifted. The SAM
has to be inserted according Figure 11: Installation of a SAM. The golden contacts of the chips are
facing towards the PCB when the socket is closed. After the socket is closed it has to be locked
again by pushing it slightly towards in direction “CLOSE”. Afterwards the housing could be closed
and the screws could be replaced.
Figure 11: Installation of a SAM
NOTE:
The maximum tightening torque of the housing screws is 0,30 Nm.
