building-up of limestone in the steam chamber and it is therefore important
to follow the self-cleaning procedure at regular intervals.
Unplug from the wall outlet and pour water in the delivered beaker. Push
the steam selector to ” ”. Keep the iron horisontally and open the water
filling inlet. Pour water slowly in the water filling inlet. Add water, but note
the MAX marking. Close the lid. NOTE: If you want to iron with steam it is
important that the iron is heated, before you switch the steam selector to
steam.
Steam ironing
Steam ironing is only possible at high temperature settings “COTTON/
LINEN”. See the above table.
• Be sure to unplug from the wall outlet.
• Add water through the water inlet (the water tank should be filled to at
last ¼) as described above. Remember to set the steam selector at ”0”
first in order to prevent water from running out.
• Plug to a wall outlet and set the temperature selector at the wanted
temperature. The signal lamp goes on during warming up and goes out
when the iron has reached the set temperature. The iron is now ready
for use. The signal lamp goes on and off during use to indicate that the
thermostat keeps the correct temperature.
• Finally, push the steam selecting button to the wanted position and start
ironing.
When steam ironing at too low temperatures some dripping may be seen
from the soleplate as the water in the tank will not evaporate sufficiently
fast. Consequently, make sure to set the steam selector corresponding to
the temperature setting.
Before you start ironing, in particular for the first time, press the spray and
steam selectors 3-4 times before ironing to activate these functions.
Burst of steam
Make sure that the water tank is filled at least 1/4. Set the temperature
selector at the wanted position within the range of ••• and wait until the
temperature has been reached (wait until the signal lamp goes off).
Lift the iron a few centimeters from the garment and press hard on the
burst of steam button. The soleplate will now release a powerful burst of
steam onto the garment. It may be necessary to activate the burst of steam
button a couple of times in order to ensure the optimum power of the pump
in the iron. Wait a couple of seconds between each pressing.
Note that the burst of steam can only be activated at high temperatures.
44
2111_2112_IDV_UVN_0115.indd 44
2015-01-30 12:48:18
Содержание 2111
