8 |
P a g e
Setup: Receiver Collar
Prepare the Receiver Collar for First USE:
Please charge the Receiver Unit(s) for approximately 30 - 45 minutes
Open the rubber cover and connect the charger connector into the charging hole
Plug the charger into a standard outlet
The red LED will flash indicating charging is in progress
Once it is fully charged, the LED will turn OFF automatically
Put the rubber cover back to ensure a watertight seal
Receiver Collar
1. To TURN ON the Receiver Collar, press the On/Off button.
2. Once Turn ON, the LED will turn RED to signal it is operational.
3. When a recharge is required, the receiver collar will beep for 20 seconds.
4. When the Receiver Collar enters Standby/Sleep Mode, the RED LED light will be turned off
5. Any movement detected by the Receiver will bring it out of Standby/Sleep Mode.
Note:
When you turn the receiver ON, if the receiver collar beeps for 20 seconds, you need to recharge it before using.
Syncing Remote Transmitter and Receiver Collar
1. Turn on the Remote Transmitter by pressing the Power Button for 2-3 seconds.
2. Select Channel A or B to sync each Receiver Collar.
3. Turn on the Receiver Collar by pressing ON/OFF button.
4. Then press the ON/OFF button once more, the RED LED light will begin to flash for 10 seconds to indicate encoding
mode.
5. Press any Command button on the Remote Transmitter immediately to sync.
6. If the sync was successful, the RED LED light on the Receiver will flash quickly.
Testing
Static Shock Test
Secure the included Test Bulb Kit and wind its metal wire on the Receiver Collar’s Contact Points.
Press Static Shock Button on the Remote Transmitter.
Be sure the level setting is not set to zero.
The test bulb will light up indicating the shock feature works.
ObeDog Ultra / Ultra Dual Training Collar: 3.7V 180mAh Lip
Operation
