10 |
P a g e
General Tips and Training Guide
The
ObeDog Stride / Stride Dual
Receiver Collar is not designed to be worn constantly. We recommend the
Collar not be worn for more than 12 hours out of a 24-hour period.
Most dogs will feel uncomfortable at first when wearing the collar for the first time. Don’t use any commands until
your dog has gotten used to the collar.
Eliminate one improper behavior or teach one obedience command at a time. If you move too quickly with
training, your dog may become confused.
Be consistent. Give your dog the same stimulation for each improper behavior.
We suggest you use Vibration Stimulation before starting the Static Shock Stimulation. When you follow this
training method, your dog will learn that Static Shock Stimulation might come after Vibration
Stimulation. Hence, the Vibration Stimulation alone can effectively cure improper behaviors of your dog without
using Static Shock Stimulation.
Do not over-correct. Use as little stimulation as possible to train your dog.
Setting up a scenario in a training session can dramatically improve your chances of success.
Should your dog reacts to the training by hiding or reacting fearfully, redirect his attention to a simple and
appropriate command such as “Sit” to calm him down.
Troubleshooting
My ObeDog Stride / Stride Dual System is not working?
Charge the Transmitter and Receiver Collar for approximately 30
– 45 minutes individually first.
Make sure the Transmitter is turned ON by holding the Mode Button for 5 seconds.
Check the levels of Vibration or Static Shock stimulation.
Intensity levels ha
s to be higher than “0” in order for Vibration and Static Shock Stimulation to work.
Make sure the Receiver Collar has enough power to operate.
Restart the Receiver collar by pressing the ON/OFF button.
Make sure the Contact Points are placed snugly agains
t your pet’s skin.
If all of above does not work, you can re-
sync the remote Transmitter and Receiver Collar. (Refer “Syncing
Remote Transmitter and Receiver Collar” of Setup/Operation Guide)
My ObeDog Remote Transmitter does not work
Check if Transmitter is low on battery, the symbol
will show up on the right down side of LCD screen.
Hold the Remote Transmitter for 5 seconds to turn on it.
Remote Transmitter will automatically goes into Standby Mode if no instruction is detected within 10 seconds.
Press any button except LED Light button to re-activate the Remote Transmitter.
My ObeDog Receiver Collar starts to beep for 20 seconds when I turn it on
The Receiver Collar will beep for 20 seconds on Low battery status. Charge it for approximately 30
– 45 minutes
and the beeping sound will go away when it’s fully charged.
Regular Maintenance
Check Contact Points for tightness weekly
Clean Contact Points with alcohol weekly
Check your dog’s neck for irritation weekly
Charge both the Transmitter and Receiver
collar as least once a month especially when it’s not in use to prevent
damage to the rechargeable batteries.
General Tips & Training Guide
