6 |
P a g e
Charging the Ergo-X
Should the LED indicator starts blinking RED, it means the battery needs to be recharged. During a charge, the LED light
will stay solid RED. Once it’s fully charged, the red light will turn green signifying charging is complete.
1. Open the Battery Charging Rubber cover on the No Bark Collar and plug in and connect the USB connector to the
adaptor.
2. Plug the Charger into an electrical power outlet with ordinary household voltage (110-230V).
3. Fully charged within 1 hour.
Strap Installation
To install the Collar strap, first unscrew the contact points and put screws in desired holes, then tighten the contact points
as shown below.
Testing
1. Turn the Intensity Dial and set to the “V” Level.
2. Turn the Sensitivity Dial to the “T” Level.
3. Test by scratching the Testing Strip on the receiver (as shown in the diagram) using a pen. The receiver will emit a
vibration for 1.5 seconds.
Setup / Operation Guide
