OBaby ZeZu Pramette, Инструкция по эксплуатации

Страница: 6 / 7

Using the Carrycot
Fitting the Car Seat on the Chassis
To convert the stroller into the pram, first recline the backrest (see page 11 for details).
Then press the buttons on either side of the seat unit (fig.36 & 37) and tilt the seat until
it is flat (fig.38).
Unclip the clasp behind the footrest (fig.39 & 40).
Remove the bumper bar (see page 7 for details) and add the carrycot liner and apron if
required.
The position of the hood can also be changed by removing the press-studs attached to
the backrest and re-attaching them to the pram rim.
To put the car seat onto the chassis, remove the stroller seat unit. Then fit the car seat
by lining up the car seat coupler with the chassis fittings on each side (fig.45), ensure it
clicks into place on both sides.
You can adjust the handle position by pressing the red button on each side of the car
seat (fig.46).
To remove the car seat from the chassis, press the release buttons on either side of the
car seat and lift the car seat up, away from the chassis (fig.47).
fig. 36
fig. 45
fig. 39
fig. 37
fig. 46
fig. 40
fig. 38
fig. 47
fig. 41
“Click”
“Click”
Adjusting the Backrest
To lower the backrest, grip the buttons on the top and bottom of the toggle behind the
seat and slide the toggle away from the seat along the straps (fig.42 & 43).
The lift the backrest, grip the sides of the toggle with one hand and the strap with the
other hand and slide the toggle up the straps to the required position (fig.44).
fig. 42 fig. 43 fig. 44
1.Press
Press
2.Lift
WARNING: Ensure that all locking devices are engaged before use
10
11
www.obaby.co.uk
www.obaby.co.uk