Turning the Cooler On
Note: Ensure cold water reservoir and hot tank have been filled with water prior to turning
on hot tank switch as an empty tank can cause the dispenser to overheat.
Turning On the Hot Tank
•
Push the red, hot tank switch (located on the rear of the cooler) to the “On” position.
Activating Nightlight
•
Turn the Green Power switch located on the rear of the cooler to the “ON” position.
•
To turn the light “OFF”, push the green switch to the “Off” position.
•
The “O” is OFF and the “I” is ON.
Dispensing Water
Replacing the Bottle
This unit has been sanitized prior to packaging and shipping.
During transit, dust and odors can accumulate in the waterways.
Dispensing Cold Water
After setup, it may take 1-2 hours to get water to cold temperature. The compressor may run
continuously during that time. This is normal.
•
Position glass, bottle or other container below spigot.
•
Press cold water button to start flow.
•
Release button when desired fill level is reached.
Dispensing Hot Water
After setup, it may take 15-20 minutes before the hot water to temperature.
•
Position glass, bottle or other container below spigot.
•
Press red button in and then depress the hot water button to start flow.
•
Release button when desired fill level is reached.
A flashing yellow light on the front panel will activate when the bottle is empty. Replace the
bottle as soon as possible.
DO NOT dispense hot or cold water if the red light is flashing as it could empty the tanks and
cause the unit to overheat.
•
Open Lower door.
•
Slide bottle out of cabinet.
•
Remove dip tube from empty bottle and place on hanger.
•
Place fresh bottle on outside of cabinet and wipe down with a clean rag. Remove entire
plastic cap from bottle.
•
Place dip tube into bottle. Slide collar down until it clicks into place.
•
Slide bottle into cabinet and close door.
