Oasis NNEBFEZ, Руководство по установке

Страница: 16 / 37

Section 4: Installation
16
10. If the outer edge of the drip tray is not properly aligned, loosen the screws on the back
of the drip tray support bracket and slide the bracket forward or backward as needed.
Then retighten the screws.
11. Once the wrapper has been installed, loosen the side bracket mounting screws until the
bracket can be slid up and down. Adjust the bracket until the mounting hole screws
through the slot and then drive in one of the #8 Torx screws and then tighten the two
#10 mounting screws.
Slotted
Holes
Incorrect alignment
#8, T15 Torx Screws
(1 each side) x2