5
SHIPPING SUPPORT REMOVAL / GRILLE & TOE
-
KICK REMOVAL / REMOVING CASE FROM SKID
1. Removing Caster Shipping Support (or
Shipping Support Bracket) Attached To Skid
•
Remove screws holding shipping supports (or
shipping support brackets) to skid. Discard.
•
Note: Shipping supports and/or brackets will vary
in size, shape, material and location depending
upon case type and model.
•
See illustration below
-
left.
2. Remove Front Grille, Rear Grille and Side
Panels Before Removing From Skid
•
Grilles and lower side panels may be attached to
case during shipment.
•
If they are attached to case, they must be
removed prior to skid removal.
•
Screw removal may be required.
•
After case is in position (and level and plumb, if
case has levelers), you must reattach these
components to case.
3. Remove Case From Skid
•
To prevent damage, support case (while sliding
it toward edge of skid).
•
For units with casters, casemay be rolled off skid
via ramp (as shown below
-
right) and into
position.
•
For units with legs/levelers, carefully slide case
off skid (at one end). Then slide skid out from
under case at other end (as shown immediately
below).
•
Use adjustable wrench and/or pry bar to level.
•
Case must be level & plumb after it is in position.
Side View of Case (With End Panel
Removed For Illustrative Purposes Only)
Note: Front Grille, Rear Grille and Side Panels
Must Be Removed Prior To Skid Removal To
Prevent Damage To Components!
Pry Bar
Adjustable
Wrench
Sample Caster Shipping
Support (To Be Removed
And Discarded)
Sample Shipping
Bracket (To Be Removed
And Discarded)