V SERIES V310 | V390 | V480 VARIABLE 3 SPEED POOL & SPA PUMP
INSTALLATION AND OPERATION MANUAL
[email protected]
oasisaquatics.com.au
7
OPERATION
STARTING THE PUMP
To operate efficiently and to prevent damage to the pump there must be a free flow of water to
and from the pump. Before starting ensure that:
•
All pipe work is correctly sealed.
•
Barrel unions on the inlet and outlet are hand tightened and the pipework is installed
square to the pump.
•
The pool/spa water level is at the correct height.
•
That all appropriate valves are open and there is nothing preventing the flow of water
through
the system.
1.
First prime the pump by removing the strainer basket lid and filling the strainer basket area
with water. Replace the lid, ensuring that it seals on the large o-ring.
2.
Connect to the power supply and switch on.
3.
Allow the pump to run, so that any air trapped in the pipe work and pump may be expelled.
4.
If prime is not established within approximately two minutes, as evidenced by a strong flow of
water from the outlet, switch off the pump for 10 secs and repeat the procedure. Continued
evidence of air under the hair and lint pot lid indicates an air leak in the suction piping work,
which should be rectified to avoid pump damage.
5.
If water flow through the pump is continuously tedious to obtain at start-up after cleaning the
lint basket, then an examination of the system to establish a reason and correct the cause.
(ie. Check valve, air leaks, faulty seal/s, crack lid.
V SERIES VARIABLE SPEED CONTROL
V Series
