Oase ProfiClear Premium TF-XL, Руководство по эксплуатации

Страница: 75 / 444

- EN -
75
6.8 System messages
The 4-digit system message is indicated in the display by two groups of two digits in succession.
System message Functions that are still
available
Possible cause Remedy Resetting the system
message
Er11
Container cover raised
• Manual cleaning (only
nozzles, filter drum not
rotating)
Container cover raised Refit the container cover Automatic when the con-
tainer cover is replaced
Container cover incorrectly fitted Turn the container cover around so that the magnets in
the container cover are located over the signal box
Signal box not connected Connect the signal box to the control system
Er22
Water temperature >
12 °C AND the last auto-
matic cleaning process
was carried out more than
24 hours ago.
• Manual cleaning
• Automatic mode
•
Time-dependent
cleaning
• Extended cleaning time
"Extra Cleaning"
Screen elements leaking Check screen elements, replace if necessary
• Press key for 5 s
• Automatic as soon as
the level detection de-
vice is triggered
Drum seal leaking Check the drum seal
Level detection device stuck or
defective
Clean the level detection device to ensure that the
mechanism operates freely, replace if necessary.
Level detection device set incorrect-
ly
Adjust the level detection device
(→ Commissioning/start-up)
Er33
20 cleaning cycles in suc-
cession
• Manual cleaning
• Time-dependent
cleaning
• Extended cleaning time
"Extra Cleaning"
Level detection device stuck or
defective
Clean the level detection device to ensure that the
mechanism operates freely, replace if necessary.
Press key for 5 s
Screen elements heavily soiled Clean/descale the screen elements (→ Removing the
screen element)
Rinsing pump not operating
•
Clean the bottom of the container, clean the rinsing
pump (→ Cleaning the rinsing pump)
• Check the pump connection
Rinsing nozzles clogged Clean the rinsing nozzles
Filter drum not rotating
•
Check the motor connection
• Check the rotating movement of the filter drum. To do
so, check the markings (1 - 8) on the filter drum to
detect a rotating movement.
Water in the pond is severely con-
taminated.
• For the duration of the severe contamination, reduce
the flow rate until the error message is no longer dis-
played.
•
For the duration of the severe contamination, use
screen elements with a larger screen mesh size.