Oase ProfiClear Premium TF-XL, Руководство по эксплуатации

Страница: 65 / 444

- EN -
65
4.5 Installing the control system with EGC box
4.5.1 Pump fed system
•
Install the control system at a minimum distance of 2 m from the pond.
•
Protect the control system from direct sun radiation.
• The control system is splash-proof and may be exposed to rain.
How to proceed:

O
1. Either attach the control system and EGC box to the container wall or use threaded hooks to
mount it in different position.
2. If the EGC box is attached to the container wall, fit both caps onto the cap nuts.
– The caps fix the EGC box in place.
4.5.2 Gravity fed system

P
•
Install the control system at a minimum distance of 2 m from the pond.
•
Protect the control system from direct sun radiation.
• The control system is splash-proof and may be exposed to rain.
• Push both ground stakes onto the control system and push the ground stakes into the
ground.
N O T E
• Protect the control system from knocks/impact.
• Push both ground stakes onto the control system.
•
With light pressure push the ground stakes into the ground to mark the position.
If the ground is hard:
•
Detach the ground stakes from the control system and drive them into the ground.
• Then push the control system onto the stakes.
5 Commissioning/start-up
•
Thoroughly clean the pond before starting up the filter system for the first time to ensure that
the filter system is not overloaded by excessively soiled water. OASE recommends using the
PondoVac pond vacuum cleaner for cleaning the pond.
– This cleaning measure is normally not necessary for newly installed ponds.
•
It is necessary to operate the filter system for 24 hours a day during the pond season.
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
• Prior to reaching into the water, isolate (switch off and disconnect) all units/devices
used in the water.
•
Isolate the device (disconnect from the power supply) before carrying out any work
on it.