Now the WLAN connection will be established.
3.11 Why is the connection interrupted occasionally? The app indicates offline.
See 3.1; 3.2
and 3.3
4)
How can I reset the FM-Master to the factory settings
?
4.1 Reset network settings:
Use the service pin to press the service button for 5-8 seconds until the intermittent tone
sounds. Afterwards, the network settings will be reset to the factory settings. The FM-
Master reboots in Access Point mode with the default password oase1234. Entries in the
device library and in the timer are retained.
4.2 Factory reset:
Use the service pin to press the service button for about 15 seconds until a continuous
tone sounds. Afterwards, the FM-Master will be reset to the condition at the time of
delivery. All passwords, entries in the device library and in the timer will be deleted.
5)
I forgot my password. How can I connect to the FM-Master?
See 4.
6)
Why is the device list suddenly deleted?
A firmware update has been executed. For an update to a new firmware version number,
that is greater than V10.0, the device list will be deleted once. This only occurs if the
firmware version was previously lower than V10.0, and it only occurs once. Please add the
connected devices again.
7)
Why does the device list at specific point suddenly display the characters as encrypted?
Please completely reset the FM-Master WLAN once. See point "Resetting to factory settings"
in the operating manual, or see above under point 4.2.
8)
Why does E003 appear in the display?
A firmware update has been executed. Please completely reset the FM-Master WLAN once.
See point "Resetting to factory settings" in the operating manual, or see above under point
4.2.
9)
Why does the connected pump run at 100% capacity, even though I have set it to 50%?
Either the EGC connection (via EGC cable) has been interrupted or the FM-Master WLAN no
longer has power. Please restore the EGC connection to the devices or restore the power
supply of the FM-Master WLAN. When this has been done the devices will again run with the
previously set values.
If this setting is not desired, please connect the pumps to the power supply on the FM-
Master WLAN. Now if the power on the FM-Master fails the pump will come to a standstill.
When the power is flowing again, the pump will again run at the previously set value.
10)
Why does the drum filter controller show a negative value in the APP?
A total of more than 40000 rinsing processes have been recorded by the drum filter
controller. This error will be corrected through a future firmware update. In the future it will
be possible to install a ProfiClear update with the FM-Master app.
