Oase AquaMax Eco Classic 9000 C, Руководство по эксплуатации

Страница: 24 / 248

- EN -
24
Connecting the controller to the smart phone/tablet
The maximum distance for interference-free communication between the controller and
smartphone/tablet depends on the transmission power of the smartphone/tablet. Brick walls, walls
made of reinforced concrete, large metal objects or bushes and trees can dampen radio waves and
decrease the distance.
Proceed as follows Information
1. Download and install the OASE App "AquaMax Classic
Control" to the smartphone/tablet.
The OASE App is available on iOS (App Store) and Android
(Play Store).
2. If you have not already done so, switch on the wireless
connection at the controller.
(→ Switching the wireless connection on/off )
3. Activate the Bluetooth feature on the smartphone/tablet. –
4. Start the App "AquaMax Classic Control" . After a brief search, a list of available products will appear.
5. Select your pump from the list. An authentication code will be displayed on the controller for
two minutes.
6. Enter the authentication code in the smartphone/tablet. Upon successful connection, the display will change to the op-
erating instruction page for the pump.
•
Now, the pump can be controlled via the smartphone/tablet.
• The LED in the controller display blinks. (→ Controller over-
view )
7 Remedy of faults
7.1 Troubleshooting overview
Malfunction Cause Remedy
Pump does not start No mains voltage • Check the mains voltage.
•
Check supply lines.
Faulty connection between pump and
controller
Check connection, and if needed recon-
nect
Pump not switched on Switch the pump on at the controller
Pump does not transport fluid Filter housing clogged Clean strainer casings
Excessively soiled water Clean the pump. The pump automati-
cally switches on again once the motor
has cooled down.
Pump is set too low Increase the rotation speed of the pump
at the controller
The impeller unit is blocked Disconnect the power supply and re-
move obstacle. Then switch the pump
on again.
Insufficient delivered quantity Filter housing clogged Clean strainer casings
Excessive loss in the supply lines
• Select larger hose diameter
• Adjust stepped hose adapter to hose
diameter
•
Reduce hose length to minimum nec-
essary
• Avoid unnecessary connection ele-
ments
Pump is set too low Increase the rotation speed of the pump
at the controller
Pump switches off after operating briefly Excessively soiled water Clean the pump. The pump automati-
cally switches on again once the motor
has cooled down.
The impeller unit is blocked Disconnect the power supply and re-
move obstacle. Then switch the pump
on again.
Pump has run dry. Flood the pump. Fully submerge the
pump for operation in the pond.