OAKWORKS PG Series, Руководство пользователя

Страница: 5 / 40

2
IMPORTANT SAFETY INSTRUCTIONS
The use of accessories, transducers, and cables other than those specified by the manufacturer, may result in increased emissions or
decreased immunity of the table.
The table should not be used adjacent to or stacked with other equipment and that if adjacent or stacked use is necessary, the table should
be observed to verify normal operation in the configuration in which it will be used.
The table is designed to be a stand alone table used with hand held ultrasound probes. This table must not be modified or
incorporated into any other equipment.
As with any moving mechanism there are potential pinch points around and underneath the table top. It is the respon-
sibility of the operator of this equipment to insure that bystanders are not in the area below or around this equipment during
operation.
Proper operation of this equipment is very important for the safety of the operator, patient, and any other individuals in the
area of this equipment. Directions for use of this equipment are described in this manual. The operator should read these sec-
tions carefully.
Weight Limit: (patient and accessories) 550 lbs./250 kg. Do not exceed.
Be certain that the table is completely lowered without any tilt being present prior to discharging an ambulatory patient.
The patient may lose balance and fall.
This table is not suitable for use in the presence of flammable anesthetic mixture with air or oxygen or nitrous oxide.
Do not put excessive weight on the extended end (beyond the main top) of the cardio panel. Maximum capacity is 150
lbs. / 68 kg.
When lowering the table or using the Trendelenburg functions, make sure there is nothing underneath the table top that
can impede motion (like stools, cabinets, accessory parts, cleaners, etc.).
Use this furnishing only for its intended use as described in these instructions. Do not use attachments not recommended by
the manufacturer.
Close supervision is necessary when this furnishing is used by, or near children, invalids, or disabled persons.
All motor actuators & lifting columns have a duty cycle of approximately 10%, meaning 2 minutes of operation within a
20 minute period. Exceeding this duty cycle can damage this equipment.
WARNING
To reduce the risk of burns, fire, electric shock or injury to persons:
1. Unplug this furnishing from the electrical outlet before cleaning.
2. Unplug from outlet before adding or removing parts.
3. Never operate this furnishing if it has a damaged cord or plug, if it is not working properly, if it has been dropped or
damaged, or dropped into water. Contact Oakworks Customer Service before use.
4. Keep the cord away from heated surfaces.
5. Never drop or insert any object into any opening.
6. Do not use outdoors.
7. Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
DANGER
For procedures where accidental table motion is a safety concern, the handset control must be locked out.
Risk of electric shock - Connect this furnishing to a properly grounded outlet only. See Grounding Instructions in this
manual.
Electrical Shock Hazard. The power supply/control module is located under the table seat. No user serviceable parts are inside
the control box. Refer servicing to qualified personnel. Unplug wall plug prior to contact with any cables connected to the
power supply.