INSTALLATION
4
Using the 1/2” wrench, tighten all
nuts securely. Repeat steps 3-5 on
remaining corners, installing the
remaining three leg assemblies to
the skirt.
step 5
Place (1) acorn nut on each leg stud
at the
backrest end only
and tighten
with the 9/16” wrench.
step 6
ASSEMBLY
Each leg has a self retaining spring
loaded pin to adjust the height of
the table. Pull pin out and move
the leg to the initial desired height.
Release the pin and it will lock
into a hole in the leg. Repeat this
procedure for all four legs.
step 7
Turn table upright, raise backrest
and install plastic cap in pre drilled
holes on the top of each leg. (on the
backrest end only)
Note: it is recommended to have
2 or more people to assist with
moving the table.
step 8
plastic cap